Maxi Cure Cyanoacrylate Extra Thick 28g (1 oz)

USAGE

Unscrew top from nozzle. For finer applications, use the extender tip. Apply Maxi-Cure™ CA to one side of the parts being joined, then hold them tightly to- gether for 10-20 seconds. For larger bonding areas, apply serpentine beads of the CA with enough spacing to allow for the spreading of the adhesive. Insta-Set™ accelerator can be sprayed to cure the CA that oozes from joints. Full strength is reached in three hours. Wipe the nozzle clean before replacing screw-on top. Refrigerate to extend shelf life. Cured CA is stable from -40 to 220° F. Soak extender tip in acetone for cleaning.

GENERAL SAFETY INFORMATIONS ABOUT CA :
While holding the bottle upright, loosen top to relieve internal pressure, then re-tighten. Remove cap and cut off end of tip. Hold parts lightly together and apply glue on seam for instant bonding. Full strength is reached in 1 hour.

• WEAR EYE PROTECTION
• STORE IN A COOL, DRY PLACE
• WARNING: EYE, RESPIRATORY, AND SKIN IRRITANT.
• BONDS SKIN INSTANTLY.
• Contains cyanoacrylate ester.
• Do not breathe fumes. Use with adequate ventilation If contact with eyes occurs, flush with water only and GET MEDICAL ATTENTION.
• If skin bonding occurs, peel (do not pull skin apart); soak in UN-CURE'™ if necessary.
• KEEP OUT OF REACH OF CHILDREN